Wallpaper Paste Explained: Which Glue to Use and How to Apply It

Wallpaper Paste Explained: Which Glue to Use and How to Apply It

Wallpaper paste, wallpaper glue and wallpaper adhesive are three names for the same product: the adhesive that holds traditional wallpaper to the wall. What changes is the type, and choosing the wrong one is behind a lot of peeling seams.

The Main Types of Wallpaper Paste

Type What it is Best for
Ready-mixed paste Pre-mixed in a tub, ready to use Paste-the-wall wallpaper, beginners
Powdered paste Flakes or powder you mix with water Standard paper wallpapers on a budget
Heavy-duty paste Stronger formula for weight Heavy wallpapers, vinyls and textured papers
Paste-the-wall adhesive Thicker paste designed to go on the wall Non-woven, paste-the-wall wallpaper

If your wallpaper is paste-the-wall, use a ready-mixed paste-the-wall adhesive. It's the right thickness, it doesn't need mixing, and it gives you a consistent result from the first panel to the last.

Do You Need Wallpaper Glue for Peel and Stick Wallpaper?

No. Peel and stick wallpaper has its adhesive already applied to the back. You peel off the backing and stick it straight onto the wall. No paste, no bucket, no mess.

Paste is only for traditional wallpaper, including our Paste-the-Wall Wallpaper.

How to Apply Paste-the-Wall Adhesive

Paste-the-wall is the easiest way to hang traditional wallpaper. You paste the wall, not the paper, so there's no soaking, no folding and no decorating table.

  1. Prepare the wall. Clean, dry, smooth and primed. Let fresh paint or primer cure first.
  2. Mark a vertical line. Use a spirit level or laser level. Your first panel follows this line, so take your time.
  3. Roll on a thin, even layer. Paste slightly more than one panel's width at a time, so the edges never dry out before you hang the paper.
  4. Hang the first panel. Line its edge up with your vertical line and let it hang naturally from the top.
  5. Smooth it down. Brush or smooth from the centre outwards to push out air.
  6. Butt the next panel against it. Paste-the-wall panels sit edge to edge, with no overlap. Match the pattern and press the join tight.
  7. Trim and wipe. Trim top and bottom with a sharp knife. Wipe any paste off the face of the wallpaper straight away with a clean, barely damp cloth.
  8. Leave it to dry. Keep the room at a steady temperature and humidity for 12 to 24 hours.

Common Wallpaper Paste Mistakes

  • Too much paste. A thick layer oozes from seams and can show through. Thin and even is the goal.
  • Pasting too far ahead. The paste skins over before the paper goes on, and the panel won't grip.
  • The wrong type. Standard paste on heavy or non-woven wallpaper can let seams lift.
  • Paste on the face. Dried paste leaves a shiny mark. Wipe it while it's wet.

What About Removal?

The paste you use today affects how easily the wallpaper comes off later. A primed wall plus the right paste means paste-the-wall wallpaper can usually be stripped in full panels.

FAQs

What's the best glue for wallpaper?

Use the paste your wallpaper is designed for. For paste-the-wall wallpaper, a ready-mixed paste-the-wall adhesive is the best choice.

Can I use PVA instead of wallpaper paste?

We don't recommend it. PVA is hard to remove and isn't designed for wallpaper.

How long does wallpaper paste take to dry?

Allow 12 to 24 hours at a steady room temperature before you use the room normally.

Retour au blog